The interface TDM presetting systems supports the provision of nominal data and measuring program parameters for various presetting systems. The nominal data of the tools to be measured are available directly in the setting system. The measured actual data are transmitted to TDM again.
Transfer of tool parameters for tool assemblies (nominal data) from TDM to the presetting device
Transfer of the data about the tool holders from TDM to the presetting device
Re-transfer of actual measured data to TDM by tool or for all tools on a tool list
The interface enables correct tool preparation and the measurement of the tools within the specified tolerances
The systems communicate via direct database communication
The measured actual tool data is stored in TDM and is available for the manufacturing process
Retransfer of the tools planned in the NC program in the form of tool lists to TDM (basis for tool provisioning)
Provision of tool lists in the NC program, to perform functions such as programming part families with standardized tools for optimized setup
Boost productivity Tool planning from start to finish, from NC programming to machining.
Time savings Save time thanks to available nominal tool data.
Optimized processes Reduction of machine downtimes and preventing damage through electronic generation of the machine-specific tool offsets based on the actual tool data (option).